6
6
TRK
(
/
)
button
Press to return to the previous track (chapter)
or go to the next track (chapter).
Press and hold to perform fast reverse or fast
forwards.
Press to answer or end a call.
7
button
8
RESET
button
Refer to
Resetting the microprocessor
on
9 Disc-
loading
slot
Refer to
Inserting and ejecting a disc
on
10 SD card
slot
Refer to
Inserting and ejecting an SD
memory card
on page 8
11 Auto EQ
micro-
phone
input jack
Use to connect a microphone for acoustical
measurement (sold separately).
Remote control
3
2
1
6
7
4
5
8
9
a
b
c
1
Volume
(
+
/
–
)
2
REAR SRC
Press to cycle through all the available rear
sources.
Press and hold to turn the rear source off.
3
SRC/OFF
Press to cycle through all the available front
sources.
Press and hold to turn the front source off.
4
Source
mode
select
switch
Use to switch the source mode between the
front source and the rear source.
5
Thumb
pad
Use to select a menu on the DVD menu.
Refer to
Checking part names and functions
on page 6
Settings and recorded contents are reset to the factory settings.
About this manual
This manual uses diagrams of actual screens to describe oper-
ations. However, the screens on some products may not match
those shown in this manual depending on the model used.
Meanings of Symbols Used in This
Manual
This indicates to touch an appropriate soft key
on the touch screen.
HOLD
This indicates to touch and hold an appropri-
ate soft key on the touch screen.
This indicates that there is a reference or
supplementary for the key or screen.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote control out and insert the
battery with the plus (+) and minus (–) poles aligned properly.
When using for the first time, pull out the film protruding
from the tray.
WARNING
Do not ingest the battery, Chemical Burn Hazard.
This product, including the supplied remote control,
contains a coin/button cell battery. If the coin/button cell
battery is swallowed, it can cause severe internal burns in
just two hours and can lead to death.
Keep new or used batteries out of the reach of children.
If the battery is swallowed or placed inside any part of the
body, consult a doctor immediately.
If the battery compartment does not close securely, stop
using the product and keep it away from children.
Batteries (battery pack or batteries installed) must not be
exposed to excessive heat such as sunshine, fire or the
like.
CAUTION
Remove the battery if the remote control is not used for a
month or longer.
There is a danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent type.
Do not handle the battery with metallic tools.
Do not store the battery with metallic objects.
If the battery leaks, wipe the remote control completely
clean and install a new battery.
When disposing of used batteries, comply with
governmental regulations or environmental public
institutions’ rules that apply in your country/area.
Using the remote control
Point the remote control in the direction of the front panel to
operate.
p
The remote control may not function properly in direct
sunlight.
CAUTION
Do not store the remote control in high temperatures or
direct sunlight.
Do not let the remote control fall onto the floor, where it
may become jammed under the brake or accelerator.
Checking part names and
functions
1
2
3 4 5
6 7 8
9
b
a
1 LCD screen
2
VOL
(
+
/
–
) button
3
MUTE
button
4
button
Press to display the top menu screen.
Press and hold to activate the voice recogni-
tion function.
Refer to
Using the voice recognition func-
tion
on page 15
5
MODE
button
Press to switch between the Application
screen and the AV operation screen.
Press and hold to switch to the camera view
mode.
Press to turn the display off.
p
Press and hold to turn the display off when
the Application screen is available.
p
When the display is turned off, touch the
screen to revert to the original screen.
Basic operation
6
< CRD4941-A >
< CRD4941-A >
Precaution
Basic operation
Basic operation
