Resetting the microprocessor
Pressing
RESET
lets you reset the micropro-
cessor to its initial settings without changing
the bookmark information.
The microprocessor must be reset under the
following conditions:
!
Prior to using this unit for the first time
after installation
!
If the unit fails to operate properly
!
When strange or incorrect messages ap-
pear on the display
Important
If you press
RESET
, all memorized settings are
erased. For this reason, we recommend that you
record the settings in the sheet on page 128 after
you have completed audio adjustments.
1
Turn the ignition switch OFF.
2
Press RESET with a pen tip or other
pointed instrument.
RESET
button
Note
After completing connections or when you want
to erase all memorized settings or return the unit
to its initial (factory) settings, switch your engine
ON or set the ignition switch to ACC ON before
pressing
RESET
.
Feature demo mode
The feature demo automatically starts when
you select the source
OFF
. The demo con-
tinues while the ignition switch is set to ACC
or ON. To cancel the feature demo, press and
hold
ATT
. To restart the feature demo, press
and hold
ATT
again. Remember that if the fea-
ture demo continues operating when the car
engine is turned off, it may drain battery
power.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (
–
) poles pointing in the proper di-
rection.
!
When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
Before You Start
En
13
Section
02
Before
Y
o
u
Start