15
Installation
2. Install the unit into the dash-
board. (Fig. 13)
After inserting the holder into the
dashboard, then select the appropriate
tabs according to the thickness of the
dashboard material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
• After installing the unit into the
dashboard, reattach the frame.
Fig. 13
DIN Rear-mount
Installation using the screw holes on
the side of the unit
• Fastening the unit to the factory
radio mounting bracket. (Fig.
14) (Fig. 15) (Fig. 16)
Select a position where the screw holes
of the bracket and the screw holes of
this product become aligned (are fit-
ted), and tighten the screws at 2 places
on each side. Use any of binding
screws (4
×
3 mm), binding screws (5
×
6 mm) or flush surface screws (5
×
6
mm), depending on the shape of the
screw holes in the bracket.
*1 Use binding screws (4
×
3 mm) only.
Fig. 14
*1
*1
Rubber bush
Screw
Dashboard
Side bracket
Screw (2
×
3 mm)
182
53
Holder
