Pioneer AVH-2350DVD, Руководство пользователя

Страница: 7 / 80

The microprocessor must be reset in the fol-
lowing situations:
!
Before using this unit for the first time after
installation
!
If the unit fails to operate properly
!
When strange or incorrect messages ap-
pear on the display
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Note
Switch your engine ON or set the ignition switch
to ACC ON before pressing
RESET in the follow-
ing situations:
!
After completing connections
!
When erasing all stored settings
!
When resetting the unit to its initial (factory)
settings
Demo mode
The feature demo automatically starts when
you select
Source Off for the source and con-
tinues while the ignition switch is set to ACC
or ON. To cancel the feature demo, press and
hold
MUTE . Press and hold MUTE again to re-
start. Operating the feature demo while the
car engine is turned off it may drain the bat-
tery power.
Important
Failure to connect the red lead (ACC) of this unit
to a terminal coupled with ignition switch on/off
operations may lead to battery drain.
Adjusting the response
positions of the touch panels
(Touch Panel Calibration)
If you feel that the touch panel keys on the
screen deviate from the actual positions that
respond to your touch, adjust the response po-
sitions of the touch panel. Refer to
Adjusting
the response positions of the touch panels
(Touch Panel Calibration)
on page 44.
Use and care of the remote
control
Installing the battery
Slide the tray on the back of the remote con-
trol out and insert the battery with the plus (+)
and minus (
–
) poles aligned properly.
!
When using for the first time, pull out the
film protruding from the tray.
WARNING
!
Keep the battery out of the reach of children.
Should the battery be swallowed, consult a
doctor immediately.
!
Batteries (battery pack or batteries installed)
must not be exposed to excessive heat such
as sunshine, fire or the like.
CAUTION
!
Use one CR2025 (3 V) lithium battery.
!
Remove the battery if the remote control is not
used for a month or longer.
!
There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
!
Do not handle the battery with metallic tools.
En
7
Section
02
Before
you
start
Before you start