Pioneer 1200, Руководство по техническому обслуживанию

Страница: 35 / 300

BODY AND TRIM Cargo Bed
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual Page 4-11
4
Cargo Bed Installation, Continued:
2. Pioneer 1200SE:
2.1. Hold front of bed lower than rear of bed and place front edge of bed onto vehicle frame and align
bed latches (6) with latch plates (11) (Figure 4-6, Page 4-11).
2.2. Lower rear edge of bed onto vehicle and align frame hinge brackets (3) with bed hinge brackets (4).
2.3. Start the bolts (1) into left and right hinge assemblies. Use an alignment tool if necessary.
2.4. Use a small hammer to lightly tap bolts through hinge assembly.
2.5. Install nylon lock nuts (2) on each bolt (1) and tighten to 15 ft-lb (21 N·m).
2.6. Proceed to Bed Stop Bumper Adjustment on page 4-11.
BED STOP BUMPER ADJUSTMENT
1. Pioneer 1200:
1.1. Adjust the two front bumpers (16) by loosening the 1/4-20 nylon lock nuts (17) and position so that
when the cargo bed is lowered, both bumpers are centered on the bed frame weldments
(Figure 4-5, Page 4-10).
1.2. Tighten lock nuts (17) to 20 in-lb (2.3 N·m).
1.3. Adjust the two rear bumpers (18) loosening the 1/4-20 nylon lock nuts (19) until a 1/8-inch gap
between the bottom of the bumper head and the frame weldment is achieved. Do not tighten to the
frame. There is a wave washer between the bumper and frame so that the bumper will “float.” Weld-
ments on the frame should rest on these two bumpers.
2. Pioneer 1200SE:
2.1. Adjust the two bed stop bumpers (5) by loosening the 1/4-20 nylon lock nuts (7) and washers (6)
and position so that when the cargo bed is lowered, both bumpers are centered on the bed frame
weldments (Figure 4-6, Page 4-11).
2.2. Tighten lock nuts (8) to 20 in-lb (2.3 N·m).
Figure 4-6 Pioneer 1200SE Cargo Bed
2
3
4
1
TYPICAL
2 PLACES
8
7
5
6
13
11
12
TYPICAL
4 PLACES
9
TYPICAL
4 PLACES
10