Pioneer Eclipse PE420GP, Руководство по эксплуатации

Страница: 19 / 52

CAUTION! Always open service valve slowly to allow
pressure to equalize in hoses. Opening quickly may
cause the flow check valve to engage, limiting fuel flow.
TO REMOVE THE SAFE-FILL CYLINDER, reverse
procedure. Always connect or change cylinders in a well
ventilated area.
Starting the Machine
1. Check oil and fuel levels.
2. Check and clean engine dust filter.
CAUTION! Never run continuously for more than 1 hour
without cleaning or changing engine dust filter.
3. Check carburetor air filter. Change if necessary.
(See “Scheduled Maintenance”)
4. Turn propane service valve counterclockwise to
open.
CAUTION! Always open service valve slowly to allow
pressure to equalize in hoses. Opening quickly may
cause the flow check valve to engage, limiting fuel flow.
5. Allow machine to tilt backward (pad off floor) and
move throttle to idle”SLOW” position.
6. With the engine throttle lever in the idle position,
engage the starter by turning the key switch to the
starting position for approximately 5 seconds. If
the engine does not start, release the key switch
for 10 seconds, then try to start again in another 5
seconds.
7. After the engine has started, move the throttle
forward approximately halfway and allow the
engine to warm up for approximately 30 seconds.
WARNING! Catalytic mufflers require a few minutes to
warm up before effectively removing harmful emissions.
Make sure of proper ventilation during this warm-up
period!
Grinding and Polishing
1. Fill the solution tank with water. Refer to Filling
the Solution Tank.
2. After engine has started, allow approximately 30
seconds for the engine to warm up.
3. Advance the throttle lever forward until it locks in
the first detented position.
4. Turn on the Solution Control Switch.
Only Use a Vapor Cylinder!
Liquid Level
Sight Gauge
Service
Valve
Pressure
Relief Valve
Bleeder
Valve
13