4
OPERATION | STRIPING TIPS
Machine Operation:
1. The Brite Striper 1100 needs to be charged completely before you
can use it. The striper is shipped with an automatic charger.
2. Once charged, test-run the machine with water to see how it
operates. You may wish to practice with paint in an off-area before
starting your job.
3. Strain and make sure your paint is diluted to a minimum of 1 part
paint to 1 part water for Pioneer natural grass paints. We strongly
recommend the use of Pioneer Brite Stripe Pre-Mix paint. Insert
your paint bucket, with lid fully attached, into the bucket holder.
4. Insert both the discharge and suction tubes through the lid’s pour
spout. Do not stripe without the lid in place, as this will cause a
safety hazard.
5. Start your striper by turning the switch to the On position. Slowly open
the ball valve on the suction tube to achieve your desired pressure.
6. Adjust the ball valve to the desired pressure and walk at your
normal striping speed. If pump is rapidly cycling, open ball valve
until cycling stops. Cycling for more than 15 seconds can damage
pump motor. It is best to operate the pump only when striping
since the pump is self priming. This will greatly reduce wear.
7. When done or when changing paint, place pick-up tube in clean
bucket of water with P.H.D. Cleaner. Turn on pump until water
comes out clean.
Striping Tips:
1. When striping, always have the machine in motion before opening
the spray valve, thus eliminating a heavy “blob” of paint at the
beginning.
2. Simplest method for running test lines is to apply lines on paper or
in an off-area. For a sharp cut-off at the end of a line, place paper
or cardboard at the end, so the line is square.
3. Periodically clean or replace the nozzle screen and nozzle tip
located inside the spray box assembly. Inspect and clean the
strainer on the suction tube with each use.
4. Do not run your pump dry. This will greatly add wear and tear on your
pump and shorten its life.
