10
Remove the ¼ inch screw on the lock down latch and then fasten the mid lug of the green safety wires
are shown.
Caution!! You must attaches these ground wires as show!!
Make sure the screw is snug when you screw it back in. If for some reason, the hole is stripped
(like mine was on my Aerosmith) completely remove the bracket and repair the hole! Please
contact us if you need help.
Next using your nut driver, start to thread the included ¼ bolt into the rear bracket. Hold off on
putting the green wire under the bolt until you have the hole fully started. Drive the bolt in half
way and then remove the bolt and put the bolt through the remain lug of the green wire.
Fully fasten the bolt.
Instert the femal end of the interface cable into the male pin header as shown. Secure the wire in the
cable clamp.
