Pinnacle Spas LUXURY DX 5000, Руководство пользователя

Страница: 26 / 70

Page 24
For HELP, call 800.304.9684
Operational Checks for Models LX 4000 – LX 11000
Caution: Do not turn on any pump until your hot tub is properly filled
with water. Running any pump without water in your hot tub
can cause IMMEDIATE damage, which is not covered
under warranty!
By now you have rechecked your hot tub’s mechanical connections and
filled it with water to about 1” above all jets by adding cold tap water
through the pre-filter (if equipped). Turn on power to the hot tub at the
main breaker panel and test the operation of the electrical system. If you
encounter a problem, please reference the troubleshooting guide on
page 44.
1. Turn on the breaker and test the operation of the Ground-Fault
Circuit Interrupter (GFCI) breaker by pushing the small button. This
should automatically trip the hot tub's circuit breaker.
DANGER: If this breaker does not trip, immediately call your
electrician. Do not use your hot tub!
Only if pushing this button successfully trips this circuit breaker
should you reset this breaker and proceed to the next step.
2. Go to the topside control panel. The hot tub first goes into a 5-minute
Priming mode, indicated by “Pr” message. Water heating is disabled
during priming. To exit Priming mode and begin normal hot tub
operation, press “Up” or “Down” button.
3. Press the Jets (Jets 1) button. You should hear the pump turn on,
see water circulating, and see the Jets light illuminate on the panel.
4. Press the Jets (Jets 1) button again. You should hear the pump turn
on a higher speed.
Caution: If water is not flowing from the jets after 2 minutes, turn
the power off at the main panel and bleed air from the
system (see page 43). Turn the power on again.
Sometimes momentarily turning the pump off/on will
help to prime. Only do this four times.