9
Step 2:
Assemble the rear wall panels
You will find it easier to assemble your shed using sawhorses with timber studs attached (timber needs to be the same length as the
shed (3.0m) or alternatively, a trestle table.
Place 4 x part S96 (Sheet) on your worktable and then position parts 27I, 27H (top channel) and parts 27C, 27D (bottom channel)
to the sheeting by tapping (diagram A) or sliding them into place (diagram B). Make sure the small lip of the channel is always
facing out. This ensures rain water cannot build up inside your shed. Make sure parts 27I and 27H are used as top side channels
as per the diagram below.
RIDGES FACING UP
ROOF TOP EDGE
27I
27H
27C
27D
S96
S96
S96
S96
A
950mm
