Pinion C-Line C1.12, Руководство пользователя

Страница: 17 / 36

InstallatIon work
17
InstallIng or rePlaCIng shIftIng Cables
www.pinion.eu
you operate your pinion gearbox with 2 shifting cables.
the clamps for the shifting cable ends are in the rotary shifter.
it is essential that you use commercially available shifting cables with dimension Ø 1.1–1.25 mm,
nipple 4.4 × 4.4 mm. genuine pinion shifting cables guarantee optimum shifting behaviour and can
be ordered from one of the pinion bicycle dealers.
as a tool for dealing with breakdowns when you are out riding, you will find a bit
(size 1.5 mm/4 mm) inserted inside your rotary shifter (1) – this fits the clamping screws of the cable
clamps. you can use the rotary shifter cover as a tool holder if necessary.
during installation of the shifting cables, you will need to move the sun gear of your
pinion gearbox, so it is a good idea if the right crank and chain ring are fitted. this makes it much
easier for you to brace the selector shaft.
Î Î
unscrew housing screw (2) of the rotary shifter cover (3) .
Î
Î
unhook rotary shifter cover at top and remove.
1,5 mm 4 mm
0,4 N·m (4 lbf·in) max.
3,5 mm
12
0,4 N·m (4 lbf·in) max.
1,5 mm
13
4
the clamp screws are easily accessible at rotary shifter positions 01 and 12 or
01 and 09 or 01 and 06 depending on the type of your pinion gearbox.
Î Î
slacken clamp screws (4) – 2× per shifting cable end.
Î Î
pull shifting cables out of the rotary shifter.
Î
Î
cut off the spliced-on shifting cable ends with a sharp wire cutter.
Î Î
First, screw in adjusting screws (5) completely – then unscrew 3 revolutions.
•
•
this ensures an adequate adjustment range for subsequent adjustments of the transmission.
1
2
3
5