i. Removing the existing screen
Remove the back door and unplug the three cables from the display
driver board (micro-USB, HDMI, ribbon cable). Unscrew all the bolts
from side panel D and remove the panel; you may need to disconnect
the spade connectors from the button on the side panel.
ii. Disassembling the existing screen
Remove the marquee pieces and lay them aside. Remove the whole
screen assembly and remove the nuts and bolts from the four corners
of the screen assembly.
You’ll be using these M3 nuts and bolts (although just two of them) to
hold the new 10” assembly together.
You’ll also need the BASE 2 piece and the large front acrylic piece from
the existing 8” screen assembly, so set those aside.
Note that the keypad and keypad ribbon cable are interchangeable
between the 8” and 10” displays, so you can use your existing one if
you wish.
Move on to 2. Building the screen now, and then follow i) in reverse to
reassemble the cabinet when you’ve built the new 10” screen
assembly.
This is for users with an already built 2018 edition Picade who
want to upgrade the screen. Complete these steps, then turn
over.
NOTE!
10” screen UPGRADE
2019.01.03
C:/Users/PiratePete/Arrr/Shiny/Picade10InchUpgrade.pdf
© 2018, 2019 Pimoroni Ltd.
