Pima WRN, Руководство по установке

Страница: 2 / 8

-2-
How to mount and connect the WRN
1. Insert a slotted screwdriver to the niches at the bottom of the receiver and remove the backplate.
2. Pass the four bus wires (not supplied) through the backplate and mount it on a flat surface.
3. Connect the bus wires using the supplied connector, making sure to follow the numbering on both the control panel’s KEYPAD
terminals and the receiver (terminal #1 on the control panel connects to the same terminal on the receiver, etc.).
4. Close the enclosure.
5. Set the receiver in the control panel.
6. Test the receiver.
The LEDs
LED label Color and state Description
RUN
Green solid Voltage OK
Green blinking Voltage fault
Off Receiver fault or power loss
DATA
Red solid Bus communication fault
Red blinking Bus communication OK
Off Wiring fault
FAIL
Red 1 blink Invalid frame received
Red 2 blinks Receiver not receiving signals from the control panel
(possible loose connection in the bus's wire no. 4)
Red 3 blinks Control panel not receiving signals from the receiver
(possible loose connection in the bus's wire no. 3)
Red 4 blinks Fatal communication error
Off No fault exists
Rx Red 1 blink Unregistered peripheral received
VALID Green 1 blink Registered peripheral received
Ordering Information
 WRN143 P/N: 8500036  WRN187 P/N: 8500037