2
RXN-700 Installation guide
INSTALLATION
1.
Connect the RXN-700 to the BUS wires to the keypad’s terminal block female connector,
according to the following diagram:
Figure 2.
RXN-700 wiring diagram
The voltage wires must be 1mm in diameter. To use 0.5mm wires, a
second wire must be added to each wire, so there would be two 0.5mm
wires for the (+) connection and two for the (-) one.
2.
Attach the mounting plate to the RXN-700 (see the next figures): insert the fastening pin
on the metal plate to the keypad’s fastening pin hole at the back, and firmly push one
against the other.
Figure 3.
The RXN-700 back side
1 (-)
2 (+)
3 OUT
4 IN
(-)
(+)
VIDEO 1
SHIELD 1
VIDEO 2
Camera #1
Camera #2
To mains
Backup battery
Control panel
Power supply
BUS
(-)
IN
OUT
