Pima Captain 6, Руководство по установке

Страница: 31 / 44

Captain 6 Installation Guide
31
Par. Onscreen When setting to “+”
L Line Check The system will perform periodic dial tone checks when it is armed
5
L Chk in off The system will perform periodic dial tone checks when it is disarmed
D Dbl reprt “Double report” parameter. See the following section
A Reprt all “Double report” parameter. See the following section
S Smke inv.
 The smoke output will normally be disconnected, and switched to
GND when the alarm is set off.
 To set the output’s trip time, see section ‎5.3.
S 2 rng snp
 2-ring line snapping (“Answering machine override”) is enabled.
 The process of calling the control panel is as follows:
1. Call the system, wait for 2 rings and hang up;
17. Wait 10 seconds;
18. Call the system again;
19. The system will pick up the call immediately.
5.4.4.1 Double report parameters (D/A)
 The next table describes to two “Double report” parameters taken from the “Config 4”
previous screen.
 When “Double report” is enabled, telephone numbers #1 & #2 of the Monitoring Station
will be of station #1, and numbers #3 and #4 will be of station #2 (see section ‎5.2.1).
D A Description
- - No “Double report”
+ - “Double report” as follows:
1. All events are reported to Monitoring Station #1;
2. Monitoring Station #2 is reported only on arming, disarming, faults and tests.
+ + “Double report” is fully enabled: all events are reported to Monitoring Station #1 & #2
5.4.5 Config 5

Technician code
Select:
CPTN XX en 6.10

System config. :
ENTER/NEXT/END 
X5
BKB2LS4ByPsReprt
------- Config 5

set the parameters

 See section ‎3.2.4 for programming instructions of the parameters bar.
Par. Onscreen When setting to “+”
B ByPsReprt Bypassing a zone will be reported to the Monitoring Station
K RX130Kbrd The RX-130 keypad is in use. This keypad cannot be used
together with the RXN-406 or the RX-6 LED keypads.
B ByPsRqest The system cannot be armed if any zone is open, including
“Delayed” and “Entry Followers” zones.
2 EOL 2 Res All EOL resistor loops have 2 resistors and can indicate on cut
and short.
5
Regardless of this parameter and the next one, the control panel checks the line voltage every time it is
armed and disarmed, and once every 24 hours.
ENTR
ENTR