Pilz PSSuniversal multi PSSu H m F DP ETH SD, Руководство по эксплуатации

Страница: 18 / 35

Interfaces
Operating Manual PSSu H m F DP ETH SD
1002323­EN­04
18
6 Interfaces
6.1 Interface configuration
6.1.1 PROFIBUS DP
The head module can be incorporated into the PROFIBUS as slave.
PROFIBUS DP Layout
Female 9­pin D­SUB con­
nector conforms to the
guidelines of the PROFIBUS
User Group (PNO) 1: n.c.
2: n.c.
3: RxD/TxD­P (B­line)
4: CNTR­P (RTS)
5: DGND (GND ext.)
6: VP (+5 V ext.)
7: n.c.
8: RxD/TxD­N (A­line)
9: n.c.
1
5
9
6
}
n.c. = not connected
The PSSu is connected to PROFIBUS­DP via RS 485 communication. The PSSu supplies
the PROFIBUS DP bus terminating resistors with voltage (+5 VDC).
INFORMATION
The two data lines are also called A and B on PROFIBUS.
Always connect the A­line ("RxD/TxD­N") to the A­lines of all the other
PROFIBUS subscribers.
The B­line ("RxD/TxD­P") should only be connected to the B­lines of the
other PROFIBUS subscribers.
If communication is not established, check the connections using a continu­
ity tester.
}
Connect the connector housing to the shielding on the PROFIBUS cable. The con­
nector housing should be connected with low impedance to the mounting rail.
CAUTION!
Do not use the signals VP (+5 V ext.) and DGND (GND ext.) to supply
voltage to external devices! They are exclusively used to supply the
PROFIBUS DP bus terminating resistors.
6.1.2 Ethernet
Ethernet Interface