Pilz PMI m107 diag, Руководство по эксплуатации

Страница: 74 / 99

Operating Manual: PMImicro diag 7-4
Operation
Diagnostics PSS/SafetyBUS p and PNOZmulti
Event messages are sent to the diagnostic terminal from the connected
programmable safety system. The event message is evaluated in the
diagnostic terminal. In most cases, the corresponding event message is
displayed in accordance with the diagnostic configuration and is entered in
the event list. The event message contains a description of the event. A
remedy can be displayed for each event message. The remedy describes
how to react to the event. The remedy contains a maximum of 8 steps, the
so-called “Actions”.
To ensure diagnostics can be performed, please ensure the following:
• The PMImicro diag must be connected to the PG interface on the
programmable safety system.
• The PMImicro diag for diagnostics on the PNOZmulti safety relay
must be connected to the RS 232 interface.
• The diagnostic function on the programmable safety system must be
activated.
• The diagnostic configuration on the PMImicro diag must match the
diagnostic configuration on the programmable safety system.
The PMImicro diag is supplied with a default diagnostic configuration and a
default PMImicro configuration, so it can immediately be used for device
diagnostics (display of system messages). Please refer to Chapter 6 for
details of the default settings (see page 6-2).
INFORMATION
Programmable safety systems with an FS operating system version ≥ 47
and safety relays with a configurator version ≥ 5.0.0 support PVIS
expanded diagnostics.
A diagnostic configuration can be be created for these programmable
safety systems. The diagnostic configuration enables appropriate event
messages to be displayed when safety devices (MBS blocks), inputs,
outputs and flags have a defined status.
PSS event messages can also be supplemented through additional
information, which is helpful during diagnostics.