Assembly Guide
– SGSP – Senior Portable Soccer Goals
If you need assistance during installation phone us on 13 PILA (13 7452)
P 13 PILA (13 7452) E
W
www.pilasport.com.au
ABN 32 114 687 820
IMPORTANT
The information contained in this document is general advice only and is not engineers advice or certification. PILA group does not
warrant the accuracy of this information and will not be held liable for its content or outcomes. It is the user’s responsibility to check that this
information is suitable for their needs. Seek advice from your engineer if required. This document is confidential and is not to be redistributed.
Copyright ©2002-2014 PILA group® Pty Ltd. All rights reserved. Registered Trademark.
Ensure the base frame assembly and the main goal frames are at right angles to each other before tightening all bolts. The
completed goal assembly can now be tuned upright into its finished position and all bolts can be tightened.
The net clips (part #18) can now be fitted into the net tracks. 26 clips to be placed on each crossbar (part #1); 11 clips to be
placed on each one of the upright posts (part #3); 18 clips to be placed on back base bar; 6 clips to be placed on each side base
bar. 4 clips will remain as spares. Place net clips sideways into track and turn 90 degrees to lock in place. Turning the net clips
in the track can be hard on fingers so use a screwdriver to lever them around. Lock net clips into position using s/s net clip
screws (#19).
Knock in plastic end caps (#20) into the end of side base bar (part #8).
Insert anchor pegs (part #17) through anchor points in back base bar (part #9) and side base bars (part #8). Put 4 pegs on the
rear base bar and 3 on each side base bar.
Ensure goal frame is anchored securely to the ground before use and users are educated on safe portable goal post use.
Never swing or climb on goal post. Regularly check and maintain goal post prior to every use. Refer to your soccer Goal
Post Handbook for more information.
