PN 350-010000-05
P a g e
| 5
Performance Verification
With the accessory removed from the sample compartment, collect a background spectrum. Place the
10Spec accessory in the sample compartment with the alignment mirror face down on the top surface
of the accessory. Collect a transmission spectrum using the same collection parameters as used to
collect the background spectrum.
The minimum transmission of the accessory should be at least 15% at 1000 cm
-1
. If your accessory does
not meet this minimum value, contact PIKE Technologies. Please have ready the serial number of your
accessory (found on rear of accessory).
Figure 4. Typical 10Spec energy throughput spectrum.
Using Your 10Spec Accessory
In order to collect a spectrum with your 10Spec accessory perform the following steps:
1.
Place the alignment mirror face down on the top surface of the accessory.
2.
Collect a background spectrum.
3.
Remove the alignment mirror and place your sample face down on the top of the accessory.
4.
Collect a sample spectrum.
