21
Step 12
Tighten the bottom two threaded rods (2) by turning the interior wall nut
assembly (1) from the outer wall and by holding the interior wall nut assembly (1)
on the inner wall from turning. These thread rods will be tightened until the
hinged doors are eveningly gapped about ½”. Then tighten the four jam nuts (3)
to the interior wall nut assemblies (1).
NOTE:
1) Repeat Steps 5 through 12 if adding another add on unit.
2)
If this is the last 4 drum roll top to be added, use the existing sidewall and
follow the remaining steps to do so.
Step 13
Install the two bottom threaded rods (12) into the interior wall nut assemblies (1)
about ¾” Make sure that the black covers (10) are on the threaded rods (12) and
that there are jam nuts (3) on the end that is being installed.
Note: If this is an existing assembly with an interior wall (8) on the end. The hex
head bolt (6) and hardware will need to be removed from the roof (9) and interior
wall (8). It will be reused in Step 17.
