7
www.pifco.co
USING YOUR APPLIANCE
Installing the gas bottle:
1. Put the
cylinder
into the gas
heater then
install the
protection
baffle to
make sure
the cylinder
is not
displaced
when it is moved from room to room.
2. Connect the pipe to the gas valve with the
cap (make sure there is no leakage).
3. Connect another side of the pipe to the
regulator with the cap (make sure there is
no leakage).
4. Before using the heater, open the gas
valve, and close it after you are finished.
Press the “SWING” BUTTON to distribute
heat evenly around the room.
Lighting the heater:
1. Open the gas cylinder by turning the gas
cylinder valve anticlockwise.
2. Turn the gas control knob on the heater to
setting 1.
3. Press the control knob down and hold in
the pressed condition.
This will allow gas to flow to the pilot and
centre burner.
4. While holding the control knob in the
pressed position push the piezoelectric
ignition button 2 or 3 times. Each time
you strike this piezoelectric ignition you
will hear a clicking sound as well as see a
spark on the pilot burner.
5. Once the pilot has lit, continue holding the
gas control knob in the pressed position
for a further 10 to 15 seconds thus
activating the flame failure safety device.
6. The pilot and centre burner should remain
alight.
7. You may now adjust the heater setting to
Low/Med/High as required.
Turning off the heater:
1. To turn off the heater,
turn the control knob
to position 1 and
close the gas cylinder
valve by turning the
knob on the cylinder clockwise.
2. Ensure that the pilot flame in the centre
burner is extinguished.
Fitting the Irish Regulator:
1. Ensure that the flame marked on the
switch is not showing when connecting
and disconnecting.
2. Use one hand to pull up the black safety
release around the base of the regulator,
and push the regulator on to the top of
the gas bottle with your other hand.
3. Release the safety and flip the switch on
top of the regulator, so the flame symbol is
showing. When this is done correctly you
will hear it pressurise.
Regulators:
1. The type of regulator that is used is
dependant on the connection on the
gas bottle used. This may be dependant
on gas supplier and your geographical
location.
2. If you are unsure which type of regulator
you will need seek advice from your gas
supplier. Please see opposite.
Removing the Regulator:
1. Check that the temperature control is set
to ‘0’.
Piezo Quartz Ignition Button
And Temperature settings
Содержание PE201
Страница 10: ...10 CUSTOMER SUPPORT TEAM 44 0 333 220 6054 NOTES ...
Страница 11: ...11 www pifco co NOTES ...