Pifco BHFP52004, Инструкция по эксплуатации

Страница: 7 / 12

7 www.pifco.co
Installing the Back Guard:
1. Remove the nut at the back of the motor
housing and put it to one side.
2. Once this part has been removed, affix
the back guard to the motor housing. To
do this, align the three pins on the left
side, right side and bottom of the motor
housing with the three corresponding
notches on the back guard, so that the
handle on the guard is at the top of the
fan, above the blades.
3. With the back guard in position, replace
the nut onto its slot at the base of the
blade shaft, and turn it clockwise to
tighten.
Note:
Take care to secure the back guard into
place when re-tightening the nut, to prevent it
from slipping out of position.
4. The back guard should now be secured
into place.
Installing the Fan Blades:
1. Once the back guard has been installed,
slot the fan blades into the shaft and
push them into place.
Note:
Ensure the blades rotate unimpeded
and do not graze against the back guard. If the
fan blades become stuck or graze against the
guard mesh, they will need to be re-installed.
Repeat the steps above as necessary until the
blades move freely and naturally inside the
guard mesh.
Installing the Front Guard:
1. When the blades have been installed,
connect the front guard to the back
guard to complete fan assembly. To do
this, align the edges of the two guards,
ensuring the fixing bracket on the front
guard is at the top of the fan, directly
above the blades.
2. When the front guard is in place, locate
the locking clips around the rim of the
front guard and push each of these down
to secure the front guard into place.
3. Use a screwdriver to fix the screw and
locking nut through the hole at the
bottom of the grilles.
4. Your fan is now ready for normal use.
Using your appliance:
1. Press any of the 2 speed buttons on the
fan’s control panel to turn the unit on.
The fan will automatically start operating
at the desired speed.
2. Press the 0 button on the fan’s control
panel while it is in operation to turn the
unit off.
Speed Selection:
1. This fan is equipped with a choice of 2
speed settings: Low (1) or High (2). Press
the corresponding button on the unit’s
control panel to select the desired speed.
CAUTION!
Press only one of the speed
control buttons at a time. Permanent
damage to the switch housing may result
if two or more of the buttons are pressed
simultaneously.
2. Press the other speed button while the
unit is in operation to change wind speed.
The fan will automatically adjust to the
new setting within a few seconds.
3. Press the 0 button on the fan’s control
panel while it is in operation to turn the
unit off. Wind will stop emitting from
the fan grille and the fan blades will stop
rotating after a few seconds to show the
unit has been turned off.