PIETRO FIORENTINI HBC 975, Руководство пользователя

Страница: 149 / 156

149
HBC 975
Use, maintenance and warning manual
SLAM-SHUT VALVE | UNINSTALLATION AND DISPOSAL | REV. 00
EN
11 - UNINSTALLATION AND DISPOSAL
11.1 - GENERAL SAFETY WARNINGS
HAZARD!
Make sure that there are no potentially explosive ignition sources in the work area set up to uninstall and/
or dispose of the equipment.
WARNING!
Before proceeding with uninstallation and disposal, make the equipment safe by disconnecting it from any
power supply.
11.2 - QUALIFICATION OF THE OPERATORS IN CHARGE
Commissioning
Operator qualification Installer
PPE required
WARNING!
The PPE listed in this table is related to the risk associated with the equipment.
For the PPE required to protect against risks associated with the workplace,
installation or operating conditions, please refer to:
• the regulations in force in the country of installation;
• any information provided by the Safety Manager at the installation facility.
Equipment
required
Refer to chapter 7 “Equipment for commissioning/maintenance”.
Tab. 11.74.
11.3 - UNINSTALLATION
ATTENTION!
Before uninstalling the equipment, completely drain the fluid in the reduction line and inside the equip -
ment.
NOTE!
To uninstall the equipment, refer to the installation steps (see chapter 6 “Installation”) and proceed in re -
verse order.
11.4 - INFORMATION REQUIRED IN CASE OF RE-INSTALLATION
NOTE!
Should the equipment be reused after uninstallation, refer to chapters:
• 6 “Installation”;
• 8 “Commissioning”.