Operation
Input 1:
Normal Input
Input 2:
Bright Input
ON/OFF/VOLUME:
Turn Amp ON, Adjust
volume, turn amp OFF
Pilot Light:
amp is ON or OFF
Fuse Box:
Replace fuse in event of
failure
1.
Make sure the tubes are properly seated in their sockets.
2.
Make sure the internal speaker cord is plugged into the internal
speaker jack
3.
Plug in your instrument into input jack 1 or 2
4.
Plug in the power cord.
5.
Turn the ON/OFF/VOLUME knob from the 6 o’ clock position
clockwise to turn the amplifier ON, the pilot light will come on.
6.
Raise the volume from the 1 to the level desired. It may take a few
seconds for sounds to come out, wait a minute for the tubes to
warm up. As you raise the volume you will notice that the tone
changes, the preamp tube will gradually go into distortion as well as
the power tube.
7.
Now you are ready to play.
Quick Start Settings:
Single Coil (Strat)
Humbucker (Gibson)
Clean 4
1/2
4
SRV (Blues Clean)
7-8
5
Rock 9-12
6-8
Heavy Rock
n/a
9-12
