Pierce PX60LB, Руководство пользователя, Страница: 2 / 4

spotlights
Thank you for purchasing the PIERCE spotlight with wireless remote. Below you will find the specification, installation and remote
information.
SPECIFICATIONS
led
Light 16 CREE LEDs (10W)
360 Degree Continuous Rotation
180 Degree Tilt
Temperature: 6,000 K
Candle Power: 57.39 lm / W
Weight 10 lbs.
Measurements 9.29” x 7.87” x 9.6”
Power
12 VDC / 80 W
Mounting Magnet or Hard
Plug 12 V power outlet, plug with 8’ cord
Remote Wireless up to 100 ft.
A23 Battery
Waterproofing IP 65
Warranty
1 year
Origin China
HID REPLACEMENT PARTS
HID3 BULB / SM2009 REPLACEMENT REMOTE / PX-R BALLAST / PX55BAL
g
g
g
LEFT RIGHT
UP
DOWN
SOS
REMOTE USAGE
An A23 battery is used in the remote. Please note: if the spotlight is left on, it
will drain your battery.
OFF/ON
Press once to turn the light on. Press again to turn the light off.
SOS
Signal the international SOS pattern.
UP
Press continuously to go up.
DOWN
Press continuously to go down.
LEFT
Press continuously to go left.
RIGHT
Press continuously to go right.
WARNING
The LED must be connected to a
minimum of
12 volts. The spotlight
will not turn on if the battery level is
lower than 12 volts.
INSTALLATION
1. Remove from the box.
2. Route the cord to a convenient place.
3. Plug into a 12V power outlet.
4. Turn on the spotlight using the wireless remote.
PAIRING THE CONTROL AND THE SPOTLIGHT
The remote control works before coding; however, we suggest coding the control to the spotlight before
use in order to avoid disturbance from other remote controls.
Step 1: Connect the spotlight to a 12-14V direct current. The spotlight will flash once to signal there is a
connection.
Step 2: Press the On/Off button on the spotlight for 15 seconds or until the light flashes 3 times in
succession (long flash).
Step 3: Again, press the On/Off button on the remote control for 15 seconds or until the light flashes 3
times in succession (long flash). The spotlight is now paired to the control.
NOTE: Please code the light first and the remote control after, so that coding on replacement control will
take place of the original controller directly.
NOTE: In the event you misplace your control, please press the On/Off button on the remote control for 15
seconds to pair the replacement.
How to Unpair
Step 1: Press the On/Off button on the remote control for 15 seconds while the spotlight is plugged in.
Wait until the light flashes 3 times in succession (short flash), it lifts code successfully.
Step 2: Press the On/Off button on the spotlight for 15 seconds or until the light flashes 3 times in
succession (short flash). The control is now unpaired.
OFF/ON
HARD MOUNTING
Hard mount the LED spotlight
using the 6” x 6” pre-installed
square mount and included
screws.
6”
6”
g