User Manual //
13
Group
6
7
The “Group” function is only required when using several PIEGA wireless systems (more than one PIEGA connect). The music
signal is only sent to speakers within the same group. This ensures the smooth operation of up to three independent PIEGA
wireless systems in one room/flat/house.
The group display
7
shows the selected group colour and the connection status. This must correspond to the speaker in
order to operate.
NOTE:
We deliver our speakers and PIEGA connect with the group setting “white”. When using a PIEGA wireless system, we
recommend leaving the group setting as “white”.
Wireless
8
The “Wireless” function is only required to eliminate any possible disturbances. This may include no connection or a lapse/
stuttering of the music playback. The PIEGA wireless system sets up an independent wireless network to transfer data from the
PIEGA connect to PIEGA speakers. This means that the system is not reliant on your home WLAN. This ensures a continuous
transfer of data.
Should the transmission be impaired by a neighbouring wireless network, the carrier frequency of the wireless signal can be
adjusted.
Such an impairment can be determined as follows:
Your system is running smoothly, provided no clearly audible faults (interruptions, stuttering, etc.) can be made out in the music
playback, or your speakers are unable to connect to the PIEGA connect.
The following carrier frequencies are supported:
A: 5.2 GHz
PIEGA recommends using this frequency whenever possible.
B: 5.8 GHz
C: 2.4 GHz
(also used by Bluetooth, which may cause faults when it is combined with the wireless system)
GROUP
WIRELESS DATA TRANSMISSION
white
24 Bit / 48 kHz
blue
24 Bit / 48 kHz
red
24 Bit / 96 kHz
