Piazzetta E903s, Инструкция по установке и эксплуатации

Страница: 18 / 40

H07022160 / DT2000391 - 01
English
3.0 INSTALLATION
1. To install, proceed as follows:
- ensure that there is a mains electrical socket near
the stove.
- lift the stove at the front and fi t the ventilation kit into
the bottom of the stove securing it with the screws and
washers provided in the kit. (Fig. 1)
DT2011512-00
DT2032152-00
DT2032153-00
2. Insert the PT sensor into the relative hole by about
10 cm and use the fi xing bracket to secure it to the
fan support (Fig. 2).
3. Connect the hoses to the hot air outlets before
inserting the ceramic front panel.
If other outlets are required for heating adjoining
rooms, the hose dia. 75 may be branched using the
relative Y elements (supplied by Gruppo Piazzetta
S.p.A. on request); remove the knockouts from the
rear protection panel and then pass the hose through.
To convey air also to adjacent rooms, choose the
shortest route to limit heat loss.
It is advisable to avoid running the hose along very
long routes, and to insulate it properly. (see instructions
accompanying the stove).
Fig. 1
Fig. 2
Knockouts
Hole for inserting
PT sensor
PT sensor fi xing
bracket
18