PIAGGIO MSS X10 500ie Executive, Руководство по обслуживанию станции

Страница: 32 / 226

Make sure the pre-filter and drainage plug O-rings
are in good conditions.
Lubricate them and refit the mesh filter and the oil
drainage plug, screwing them up to the prescribed
torque.
Refit the new cartridge filter being careful to lubri-
cate the O-ring before fitting it.
Change the engine oil.
Since a certain quantity of oil still remains in the
circuit, engine oil must be added through plug
« A ». Then start up the vehicle, leave it running for
a few minutes and switch it off: After about five mi-
nutes, check the level and, if necessary, top-up but
never exceeding the MAX level reference mark.
The cartridge filter must be replaced every time the
oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS CHANGED.
Recommended products
eni i-Ride PG 5W-40 Synthetic based lubricant
for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Locking torques (N*m)
Engine oil filter
12 - 16
Engine oil drainage plug
24 ÷ 30
Check
This operation must be carried out with the engine
cold and following the procedure below:
- Place the vehicle on its centre stand and on flat
ground.
- Unscrew the cap/dipstick « A », dry it with a clean
cloth and reinsert it, screwing it all the way
down .
- Remove the cap/dipstick again and check that
the level is between the min and max reference
marks; top-up, if required.
Maintenance
MSS X10 500ie Executive
MAIN - 32