5 Installation
N565 NEXACT® Linear Stage
MP148E
Version: 1.4.0
13
In this Chapter
General Notes on Installation ...................................................................................................... 13
Mounting the N-565 onto a Surface ............................................................................................ 15
Building an XY System .................................................................................................................. 18
Fixing the Load to the N-565 ........................................................................................................ 20
Connecting the N-565 to the Controller ...................................................................................... 22
5.1
General Notes on Installation
NOTICE
Damage from changes in position due to external forces!
Moving the platform of the positioner by external forces can damage the drive. Changes in
position caused by external forces acting on the positioner can also damage the load or the
surroundings.
Make sure that forces acting the platform in the direction of motion do
not
exceed the
active push/pull force of the drive (p. 33) particularly when the positioner is mounted
vertically.
Trigger all motion by sending motion commands to the controller. Do
not
move the
platform by hand.
Figure 2: Accessible when the platform is moved out: Encoder scale
1
Bottom of the N-565's platform
2
Scale of the linear encoder,
do not touch!
5
Installation
