5 Installation
N470 Linear Actuator
MP125E
Version: 1.2.0
21
Installing an N470 with mounting thread
1.
Screw the mounting nut of the N-470 as far as necessary in the direction of the base
body of the N-470.
2.
Optional: Apply a small amount of lubricant to the contact surface of the moving part of
the mechanical mounting.
3.
Screw the N-470 as far as necessary into the M10×1 through-hole of the mechanical
mounting.
4.
Align the base body of the N-470 with the mechanical mounting.
5.
Fix the N-470 in the mechanical mounting:
a)
Hold the base body and screw the mounting nut of the N-470 in the direction of the
mechanical mounting.
b)
Hand-tighten the mounting nut with the hook wrench.
6.
Check that the linear actuator is fixed firmly in the mounting.
7.
Optional: Turn the screw head of the linear actuator's fine-threaded screw into the
desired position by hand to avoid longer travel to this position.
Installing an N470 with clamping shank
1.
Optional: Apply a small amount of lubricant to the contact surface of the moving part of
the mechanical mounting.
2.
Remove the mounting nut from the clamping shank of the N-470.
3.
Position the N-470 in the mechanical mounting of your application.
4.
Manually screw the mounting nut of the N-470 a few turns into the thread of the
clamping shank.
5.
Align the base body with the mechanical mounting.
6.
Clamp the N-470 firmly in the mounting:
−
Hold the base body and hand-tighten the mounting nut of the N-470 with the hook
wrench.
7.
Check that the linear actuator is fixed firmly in the mounting.
8.
Optional: Turn the screw head of the linear actuator's fine-threaded screw into the
desired position by hand to avoid longer travel to this position.