PI M-230 Series, Руководство пользователя, Страница: 29 / 47

6 Start-Up
M-230 Linear Actuators MP102E Version: 1.2 25
6.2 Starting Up the Actuator
In the following, a PC with PC software is used as the peripheral control equipment of
the controller.
Prerequisites

You have read and understood the General Notes on Start-Up (p. 23).

You have correctly installed the actuator (p. 15).

You have read and understood the user manual of the used controller.

You have read and understood the manual of the used PC software.
Accessories

Suitable controller (p. 11) - motor controller card for PC installation or stand-
alone device incl. connection cable to PC.

PC

PC software for the controller (for PI controllers: included in their scope of
delivery)

If necessary, suitable motor cable from PI, e.g.:
−
Motor cable C-815.38, 3 m, D-Sub 15 (m/f),
−
Motor cable C-815.83, 10 m, D-Sub 15 (m/f)
Starting up the actuator
1. If you use a motor controller card (e.g. C-843 from PI), make sure that it is
properly installed or install it (see the user manual of the motor controller
card).
2. If suitable and current PC software for the controller is not on your PC yet,
install the PC software (see the user manual of the controller or the software).
3. If you do not use a motor controller card, connect the PC with the external
controller using a suitable cable.
For PI products: the cable required for this is included in the scope of delivery.