User Manual
L306T0002, applies to L-306.011100 / 011112 / 013112
MMa, 2019-AUG-20
PI miCos GmbH, Freiburger Strasse 30, 79427 Eschbach, Germany
Page 12 / 25
Phone +49 7634 5057-0, Fax +49 7634 5057-99, Email
Affixing the Load to the Positioner
NOTICE
Impermissibly high load on the positioner!
An impermissible high load impairs the motion of the platform and can damage the
positioner.
When considering the mass and mounting method of the load, pay attention to the
specified maximum permissible forces that may act on the platform (p. 19).
NOTICE
Excessively long screws!
Screws and locating pins that are inserted too deeply can damage the positioner.
Pay attention to the depth of the mounting holes in the platform.
Only use screws and locating pins of the suiting length for the respective mounting
holes.
Figure 5: Position of the holes for mounting the payload
Requirements
You have read and understood the general notes on installation (p. 7).
You have mounted the positioner properly onto a surface.
The positioner is
not
connected to the controller.
You have prepared the load so that it can be affixed to the mounting holes on the
platform:
−
The distance between the center of gravity of the load and the center of the
platform is as small as possible in all directions.
−
At least two points are provided for mounting the load on the platform (ideally:
three or four mounting points).
−
If you use locating pins for aligning the load: You have made two locating holes of
Ø 4 mm H7 in the load for accommodating locating pins.
