PI 2 Design CM4AES, Справочник по аппаратуре

Страница: 10 / 22

Pi 2 Design CM4AES Hardware Reference Manual – P0.1
PAGE 10
5 CM4 PORTS AND GPIO
5.1 OVERVIEW
The CM4AES uses a number of the Interface Ports and GPIO from the CM4 for control
and status purposes.
5.2 COMPUTE MODULE 4 PORTS
Certain CM4 Port pins are hardwired and are always available when enabled. The
usage for these ports on the CM4AES is listed below in the following table.
PORT/Signal(s) CM4AES Use Description
Ethernet P8 RJ45 Ethernet Port
*LED_ACT LED1 Green LED, CM4 Activity
*LED_PWR LED2 Red LED, Power
Analog_IP0-1 Unused
Camera_GPIO Unused
*EXT_RST *RST Reset Out to Peripherals
USB_P/N USB2504A USB Host to USB2504A Hub
USB_OTG_ID USEL Factory use only
CAM0-1 Unused
DSI0 Unused
DSI1 P5 DSI Interface for LCD Display
PCIe P9 M.2 2282 NVMe Socket
HDMI0 P4 External HDMI Connector
HDMI1 P16 Internal, Vertical HDMI Connector
UART 1 P3 Serial Console
SDIO SD1 Micro-SD Card Socket
Table 4 – CM4 Ports and Usage
5.2.1 CM4 PORT NOTES
1. Ports marked unused are unavailable and not connected on the CM4AES.
2. USB_OTG is used for factory programming of CM4 eMMC. This is only
used with CM4 modules that have built in eMMC. Non-eMMC modules