ProfiNet / ProfiBus interfaces
MA 1263-A010 EN
6
3 Introduction
phy
LOGIC
TM
is the programming language to communicate with phytron programmable
logic controllers like the MCC-Series or our
phy
MOTION
TM
.
phy
LOGIC
TM
commands can easily be sent to the controller with phytron’s programming
software (
phy
LOGIC
TM
Toolbox) via USB, embedded into other protocols like Ethernet or
into interface protocols like ProfiBus / ProfiNet.
You can parameterise your commands (e.g. a driving command) per axis either just the
first time you set up your system, or adjust the parameters temporarily before sending a
driving command.
Example: For “relative run” you can set: step resolution (P45), run current (P41), run
frequency (P14), start stop frequency (P04), ramp (P15), recovery time (P16), boost (P17),
boost current (P42), current hold time (P43), etc.
Use this illustration to find the adequate manual for your programming task:
