Sensor MT9V024
PHYTEC Messtechnik GmbH
www.phytec.de
VM-010-BW-xxx
Monochrome CMOS Camera Module / Camera with Digital Interface
•
image sensor:
1/3“, Wide-VGA, 752(H) x 480 (V), APTINA MT9V024
•
pixel size:
6.0µm x 6.0µm
•
data output:
10 Bit digital parallel, monochrome, phyCAM-P
8 Bit digital serial, monochrome, phyCAM-S (LVDS)
•
frame rate:
60 frames per second (at full resolution)
•
dynamic range:
>55 dB linear / >80 dB - 100 dB in HiDy mode
•
shutter:
global shutter - TrueSNAP™
•
camera control:
numerous register settings available by I²C bus
•
power supply:
3.3V DC (±10%)
•
power consumption:
<320mW at maximum data rate / 100µW in standby
•
synchronization modes:
master- / slave- / snapshot- mode
•
operation temperature:
-25°C ... +85°C
•
dimensions:
34mm x 34mm x 6mm (without lens holder)
•
mounting:
4 x M2,5 (PCB)
•
weight:
7g (PCB)
•
connector:
33 pin. FFC/FPC, 0.5mm pitch, 0.3mm thick,
contact position bottom, phyCAM-P
8-pol. Hirose, 1,25 pitch female, phyCAM-S
•
mating cable:
33 wire FFC cable 0.5mm (e.g. PHYTEC part no.
WF062=120mm, WF043 = 200mm, WF046 = 300mm)
8-pol. LVDS. cable, RJ45 to DF13-08S-1.25C (WK216)
•
lens holder:
VM-010-xxx-H : fits to C-Mount and CS-Mount lenses
VM-010-xxx-M12 : fits to M12 / 0.5 lenses (S-Mount)
All types of the camera board VM-010-xxx can directly be connected to a
microcontroller equipped with an appropriate digital camera interface. PHYTEC offers
for example the OMAP44xx and i.MX35/31/27 carrier-/development boards, which allow
a direct connection of the VM-010-xxx. Driver software and demo applications for
various controllers are included.
Camera PCB:
frontside
phyCAM-P backside phyCAM-S
Camera with lens holder:
-H
= camera with lens
-M12
= camera with lens
holder for C/CS-mount lenses
holder for M12 / 0.5 lenses (S-Mount)
