Phytec 1337.1, Руководство по оборудованию, Страница: 37 / 44

Mounting to the phyBASE
©
PHYTEC Messtechnik GmbH 2011 L-758e_1
27
8 Mounting a Display Adapter on a Baseboard
An integral hinge is used in order to join baseboard and display
adapter together mechanically. It is part of the display adapter and
already mounted on it with two screws and an aluminum slat.
Fastening the integral hinge to the baseboard will be done the same
way. Therefore PHYTEC ships the display adapter together with a
separate aluminum slat and the baseboard comes with the needed
screws. To be able to fold display adapter and baseboard together and
to put this kit on a table in a stable manner, four plastic spacer bolts,
four rubber plugs and two nuts also belong to the baseboard.
Figure 8:
Preparing Baseboard and Display Adapter
Do the following steps:
•
Lay down the aluminum slat on the table.
•
Put the display adapter beside it so that the holes of its integral
hinge match the holes of the aluminum slat.
•
Position the baseboard so that its corresponding two holes also
match and that its corresponding border will be flush with the
aluminum slat as shown in Figure 8. It might be necessary to
flip the aluminum slat in order to achieve this.