①
When the camera is off,switch the receiver to the ON position,take the 2.5mm cable to connect the 2.5mm
socket of receiver and the shutter port of camera,after that,turn on the camera and the receiver;
②
after the successful code setting,the transmitter can control the receiver,so that it can control the camera's
sets,such as single shot mode, 2 seconds delay, continuous, as well as bulb mode for long exposures.
Precautions:
1)This product belongs to the accessory of electronic product,maybe Because of the external environment
factors,there is something wrong with the cameras,but it is a small probability event,do not panic.
2)please turn off the receiver,and take out the battery for long time unused.
3)Don't drag the cable when it is connected to the camera.
4)Don't put it in the high temperature places,such as the Enclosed vehicles and the control panels.
5)keep dry:Don't touch the product with wet hands,and it may be malfuction if immersed in or exposed to
water.
6)Don't use it in the places where the materials can easily get fire and explosion.
FCC ID: XBYWXD189RX
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY
TO OPERATE THE EQUIPMENT.
Contact Tel : (86) 0755-61116103
Contact Fax : (86) 0755-61116101
E-Mail: [email protected]
