Photron Fastcam SA5, Руководство по оборудованию

Страница: 76 / 107

Chapter. 4 Connecting a PC
64
4.1.4. Connecting Multiple Systems and a PC
With PFV, the system’s control software, one PC can connect to and control multiple FASTCAM
series camera systems.

When connecting to multiple systems, set the IP address of each one to a unique setting.
4.1.5. Gigabit Ethernet Interface Initialization
When you cannot communicate well with the camera even though you are running PFV, the
system's control software, you may be able to improve the situation by performing the procedure
below.
1. Of the four USER SW (programmable switches) on the back of the camera body, press and
hold USER1 and USER4 for 10 seconds or more.
2. The LEDs on the rear of the camera body will illuminate back and forth from left to right and
from right to left and inform you that the initialization of the Gigabit Ethernet interface has
completed normally.

Pressing and holding on the USER SW (Programmable Switch) for more than 15 seconds will result
in an IP Address Initialization.
4.1.6. Camera IP Address Initialization
In some circumstance when the IP address is changed, and the new IP address is not explicit, an IP
Address Initialization operation is recommended. In this case, the IP address will be reset to
192.168.0.10 as the factory settings.
1. Press and hold on the USER SW (Programmable Switch) on the rare of camera for over 15
seconds.
2.
When the LEDs blink from left to right and then from right to left alternately, it indicates the
initialization operation is accomplished.