Photron FASTCAM-PCI R2, Руководство по оборудованию

Страница: 19 / 55

FASTCAM-PCI R2 Hardware Manual
- 19 -
2.3. Installation of Hardware
Warning:
Turn off the computer and unplug the power cord from power outlet before connecting between the
camera head and Grabber Board, and installing the Grabber Board in the PC to avoid electrical
shock and possible damage to the system and/or components.
Caution: Remove the cable twist-ties before connecting.
2.3.1. Installing Grabber Board in PC
Follow the procedure below to install the Grabber Board in the PC:
1.
Turn off the PC and unplug the power cable.
2. Remove covers of the PC following the PC’s instruction manual.
3. Make sure there are unused PCI slot(s).
4. Remove the metal cover plate in the back of the unused PCI slot where you wish to install the
Grabber Board.
5.
Insert the Grabber Board into the unused PCI slot. Firmly press the edge of the Grabber
Board so the connector engages perfectly. Fasten the board with retaining screws.
6.
Replace the covers on the PC following the PC instruction manual.
7
． Connect the camera cable to the camera connector on the Grabber Board. Be careful about
the connector orientation. Fasten the retaining screws tightly. Pull the cable lightly to check if
the connector does not come loose.
Caution:
Be sure to tightly fasten the retaining screws on the camera cable connector shell to avoid damage
to the system by unintentional disconnection during operation.
Warning:
Turn off the PC and unplug the power cord before installing the Grabber Board in the PC.