Photron FASTCAM-512 PCI, Руководство по оборудованию

Страница: 25 / 55

FASTCAM-512PCI Hardware Manual
- 17 -
1.4.3. Setting Up Camera ID Numbers
For the software to recognize each camera involved in a multiple-camera operation, an ID number,
from 0 to 3, is assigned to each camera. With this ID number, each camera is correctly recognized
by the system even if the order of recognition is changed.
The following shows how to assign ID numbers to cameras used in a multiple camera system.
Dipswitch Operation to Set Up Camera ID Numbers
Camera ID numbers 1 to 4 are defined by the ON/OFF position of dipswitches 1, 2 and 3 as shown
below.
ID No. Dipswitches SW 3 SW 2 SW 1
0
1
2 3 4
O N
OFF OFF OFF
1
1
2 3 4
O N
OFF OFF
ON
2
1 2
3 4
O N
OFF
ON
OFF
3
1
2 3 4
O N
OFF
ON ON
The factory-set ID is 0.
Assign ID No. 1 to the master board (or the board that receives sync signal from an external
source), and other numbers to the slaves in the order of PCI slots in the computer chassis.
Do not duplicate an ID number within a multiple-camera system.