Photon Systems Instruments LED Light Source SL 3500, Инструкция по эксплуатации

Страница: 6 / 11

6
3. Safety Precautions
•
The LED radiation may be harmful to eyes, avoid direct and strongly reflected exposure.
365 nm through 390 nm LEDs can be considered Class 1M LED Product. Wear protective
glasses!
•
The device has a built-in temperature control and safety temperature fuse. The Light Panel
switches off automatically when the Power Supply (control unit) gets heated above 70 ºC
and/or the Light Panel gets heated above 60 ºC. After cooling, the panel switches on again.
•
Even if the temperature fuse switches the device off, the manufacturer strongly
recommends to switch off the device manually and to allow its sufficient cooling.
•
Never cover the Power Supply (control unit) or the Light Panel! Low ventilation can cause
an irreversible damage to the device.
•
Keep the device dry; avoid working in a high humidity environment!
•
The LED Light Source should be always used with the original Power Supply (control
unit) supplied by the manufacturer. This control unit is an important component of the
device and should never be replaced by any other similar appliance.
•
When connecting the device modules, use only the cables supplied by the manufacturer.
The only exception may be the mains cable that differs from the DIN or CZ standard in
some countries.
•
Keep in mind that no warranty is provided for the damage due to device misuse,
modification, improper installation, negligence, or accident.
GENERAL ELECTRICAL SAFETY GUIDELINES:
•
Connect all peripheral units when the device is switched off!
•
Routinely check the devices and their wiring.
•
Replace worn or damaged cords immediately.
•
Use electrical extension cords wisely and do not overload them.
•
Place the devices on a flat and firm surface. Keep them away from wet floors and
counters.
•
Avoid touching the device, socket outlet or switch if your hands are wet.
•
Do not perform any alterations to the electrical part of the devices or its components.