06
07
Stability / Reliability / Creativity
Clamp fitting:
Using suitable module clamps on the LONG side of the module frame
to mount the modules is “portrait orientation” mode, while on the SHORT side of the
module frame is “landscape orientation” mode.
The module clamps should not come into contact with the front glass and must not
deform the module frame. Avoid any shadowing effects from the module clamps.
The module frame can not be modified under any circumstances. Regardless of the
orientation chosen, at least 4 clamps must be used on each module. For portrait
orientation, 2 clamps should be attached to the long sides of the module and for
Clamp
Mounting Rail
M8 Screw
Module Frame
Module installed using Clamp Fitting method
Select the appropriate installation method depending on the load (see below for more
detailed information).
F Type
1580mm × 808mm × 35mm
DIAMOND Series
ONYX Series
U Type
1640mm × 992mm × 35/40/45mm
DIAMOND Series
ONYX Series
T Type
1956mm x 992mm x 45/50mm
DIAMOND Series
ONYX Series
Module Frame
Mounting Rail
M8 Screw
Split Washer
M8 Bolt
M8 Nut
Flat Washer
Mounting Rail
Module Frame
Module installed using Screw Fitting method
landscape orientation 2 clamps should be attached to the short sides of the module.
Depending on the local wind and snow loads, additional clamps may be required. The
applied torque should be about 8Nm. Please find detailed mounting information in the
below illustration:
3.3 Select suitable mounting methods
PHONO SOLAR modules can be mounted using two methods:
Screw Fitting:
Use corrosion-proof screws in the existing installing holes in the
module frame. Each module has 8 mounting holes for securing the module on the
mounting rail. The module frame must be attached to a mounting rail using M8
corrosion-proof screws together with spring washers and flat washers in symmetrical
locations on the module. The applied torque should be approximately 8Nm. Please
find detailed mounting information in the below illustration:
