Phonic WM400-L, Руководство пользователя, Страница: 6 / 22

6
WM 400-R / 400D-R / 400-L / 400D-L
7. Up and Down Buttons
(WM400D-L and WM400D-R only)
These buttons are used to adjust the
properties of various features built-into
the WM400D’s. Pushing up or down will
initially simply allow users to adjust the
channel that the transmitter is using. If
you push both of these buttons at the
same time, it will jump to the next setting
that can be edited. You can then adjust
the properties by pushing the up and
down buttons. These settings will come
in the following order:
Channel Settings: CH 0 – CH 9,
CH A – CH F
Delay Settings: 0.0 – 00.0 milliseconds
EQ Mode: P1 – P0 (see the EQ table
for a full rundown on EQ presets)
Low Cut Filter: L 0 (Hz) – L 1 (kHz)
High Cut Filter: H 0 (kHz) – H 60 (Hz)
The high and low cut filters are adjusted in 1 Hz
increments; 10 Hz increments when over 1 kHz.
8.
Channel Selector
(WM400-L and WM400-R only)
Adjusting this dial to one of the preset
channels allows the WM400 to know
which pre-set frequency to look for
the wireless information. The wireless
transmitter should be set to the identical
channel if transmission is to occur suc-
cessfully.
9. On Indicator
(WM400-L and WM400-R only)
This LED indicator illuminates when the
WM400(D) receiver is powered.
10. Antenna
This is the WM400(D)’s antenna. Adjust
it so it sits in a vertical position when the
device is in use (change the position if
the wireless signal quality is poor). Push
the antenna in to release it before ad-
justing its position.
WM400D
1
4
5
6
7
1
10
WM400
10
1
9
5
8
1
10
11
11. DC In and clip
Plug DC end of the supplied DC power
adaptor (1V, 00mA) into this jack, and
the other end into a suitable AC power
source to allow the WM400(D) to be
powered. The accompanying clip en-
sures the DC head of the power supply
is kept securely in place.
1. XLR Output
This jack accepts XLR connectors to
feed the signal from the Wireless Re-
ceiver to the Speaker.
1. Fixing
Use this hole to secure the WM400(D)
receiver into the mounting socket of your
speaker by use of the accompanying
M6, M8 or M10 screws and a washer.