Phonic POWERPOD 745, Руководство пользователя

Страница: 11 / 20

page 10
POWERPOD 745 / 865 / 885 User's Manual PHONIC
page 11
PHONIC CORPORATION POWERPOD 745 / 865 / 885 User's Manual
Digital Effect Section
23. Digital Effect Display
This panel displays the titles of different effects that can
be added to audio. When you select the effect, the LED
imbedded next to the effect name will illuminate and the
alteration be applied automatically.
24. Program Control
This control is used to scroll through the various effects
shown on the Digital Effect Display. Turning the control
will automatically change the effect and apply it to the
mix.
25. Parameter Control
(Powerpods 865 and 885 Plus only)
This will adjust the one main parameter of the digital
effect that is currently applied to the audio feed. Please
refer to the Digital Effects Table for more information on
Effect parameters.
26. Peak Indicator
(Powerpods 865 and 885 Plus only)
This LED indicator will illuminate when the Digital Effect
Processor overloads. It is best to adjust the Effect control
on input channels so as to ensure the Peak indicator
does not light up. This will ensure a greater quality over-
all of audio.
27. DSP Effect On Button and Indicator
This button is pushed to turn the corresponding effect
panel on or off. When the effect processor is turned on,
the corresponding LED illuminates.
28. Tap Delay Button and Indicator
(Powerpods 865 and 885 Plus only)
When the tap delay effect is selected, this button is used
to determine the delay time. By pushing the button
several times, the mixer interprets the time between
last two pushes and remembers this as the delay time
until the button is pushed again. When the tap delay
effect is selected, the corresponding LED will flash at the
intervals selected.
Master Section
29. Graphic Equalizer and Feedback Detection System
Each of the Powerpod Molded Mixers features two 7
band graphic equalizers that allow the user to adjust the
frequency response of the Main Left and Right signals
(Main 1 and 2 on the Powerpod 745 Plus) or Monitor and
Main signals, as selected by the GEQ select switch. The
graphic equalizers provide a maximum of 12 dB of cut or
boost on each frequency.
One feature, built into the Powerpod Molded Mixer graphic
equalizers, is a Feedback Detection System . The individ-
ual LEDs located on the slide VR controls of the equalizer
will illuminate when feedback occurs on those particular
frequency band. By reducing the level of any frequency
band that has an illuminated LED you can quite effectively
remove feedback from
your audio; after which
the LED will turn off.
If an LED flashes,
yet you are unable to
hear any feedback, it
is probably best not to
adjust the level. When
feedback occurs, the
LED will generally light
up and remain lit.
30. EFX to Mon/Main Controls
These controls, one located below each of the Graphic
Equalizers, allow users to adjust how much of signal
processed by the built-in effects processor is sent to the
Main or Monitor mixing buses accordingly.
31. Tape In Controls
These controls, located below each of the Graphic Equal-
izers, are used to adjust the level of the Tape In input that
will be sent to the main or monitor mixes, accordingly.
32. AUX In Control
This control, located
below the Main
Graphic Equalizer, is
used to adjust the level
of the AUX In input,
that will be sent to the
main mix.