Phonic MU 200 XP, Руководство пользователя

Страница: 5 / 20

PHONIC CORPORATION Page 4 MU 200XP USER ’ S MANUAL MU 200XP USER ’ S MANUAL PHONIC CORPORATION Page 5
GETTING STARTED
1. Ensure all power is turned off on your mixer.
To totally ensure this, the AC cable should not be
connected to the unit.
2. All faders and level controls should be set at the
lowest level and all channels muted to ensure
no sound is inadvertently sent through the
outputs when the device is switched on. All levels
can be altered to acceptable degrees after the
device is turned on using the channel setup
instructions.
3. Plug any necessary equipment into the device’s
various outputs. This could include amplifiers and
speakers, monitors, signal processors, and/or
recording devices.
4. Plug the supplied AC cable into the AC inlet on the
back of the device and then into a power outlet of a
suitable voltage.
5. Turn the power switch on and follow the channel setup
instructions to get the most out of your equipment.
CHANNEL SETUP
1. To ensure the correct audio level of the input channel
is selected, each of the level input controls of the
Mixer should be turned counterclockwise or down as
far as they will go.
2. No input other than the one being set should have
any device plugged in. This will ensure the purest
signal is used when setting channels.
3. Set the level and AUX 1 controls of the channel you
are setting to the 0 dB mark. Also set the Main L-R
fader to the 0 dB mark.
4. Press down the AUX 1 button on the control room
source section, allowing the level meter to display
the level of the channel being set.
5. Ensure the channel has a signal sent to it similar to
the signal that will be sent when in common use. For
example, if the channel is using a microphone,
then you should speak or sing at the same level
the performer normally would during a performance;
if a guitar is plugged into the channel, then the guitar
should also be strummed as it normally would be (and
so on). This ensures levels are completely accurate
and avoids having to reset them later.
6. Set the gain so the Level Meter indicates the audio
level is around 0 dB.
7. This channel is now ready to be used; you can stop
making the audio signal.
8. You can repeat the same process for other channels.
Or not, it’s your call.