Phonic MM 502, Руководство пользователя

Страница: 7 / 16

MM502 USER ’ S MANUAL PHONIC CORPORATION
Page 7
MASTER SECTION
5 MAIN OUT
Using 1/4" TRS connector, you can send balanced
line level signals in stereo from the mixer to external
devices like recorders, graphic equalizers, amplifiers,
and etc.
6 PHONES
One 1/4" unbalanced TRS jack for connecting
headphones to monitor the main out content or the 2T
RTN content.
7 2T RTN & 2T REC
2T RTN and 2T REC accept semi-professional
signal via RCA connectors. While 2T RTN can be
connected to CD, DAT, MD, tape players for playback,
2T REC can be used with CD, DAT, MD, and tape
recorders for recording purposes. If you want to use
2T RTN to monitor the contents recorded in recorder,
you can connect both 2T RTN and 2T REC to the same
recorder. Push the “ TO PHONES” button on the 2T
RTN control section to listen to the recorded contents
and track the problems. However, please remember to
release the “ TO L/R” button at the 2T RTN control
section to avoid feedback.
CONNECTING PANEL DESCRIPTION
INPUT CHANNEL
1 MICROPHONE INPUT
Mic input on CH1 and CH2/3 accepts XLR-type
connectors. We recommend using professional
balanced dynamic, condenser or ribbon mics for
microphone input because they are the least likely to
be interfered.
When using condenser microphone, make sure
the +48V Phantom Power is turned on. See PHANTOM
POWER for more information.
2 LINE INPUT
Line input on CH1 accepts 1/4" TRS jacks. Except
for microphone signal, it welcomes signals from
sources like keyboard, electronic drum, tape recorder
and etc. When you use unbalanced 1/4" TRS jack, the
line input automatically turns the Ring into ground. The
ring must be grounded if the source is unbalanced.
3 INSERT
Unbalanced insert point accepts 1/4" TRS plug,
suitable for devices such as signal processors like
limiters, compressors (PHONIC PCL3200), and
graphic equalizers (PHONIC MQ3229/3300/3400).
When an insert is not in use, signal goes directly to its
destination. For an illustration of insert cords, see the
section entitled TYPICAL CONNECTING LEADS.
1
2
3
5
6
7
4
4 STEREO LINE INPUT
There are two sets of stereo input channels
accepting balanced 1/4" TRS plugs. When the input
signal is mono, plug into the “ L(MONO)” channel, and
the signal will be mirrored to the “ R” channel. Stereo
signals from electronic keyboard, synthesizer, sampler
or any Hi-fi stereo equipment like CD, DVD, MD, DAT
and etc., can be connected to these input channels.
For CH 2/3, do not plug into both MIC and stereo line-
in (L/R) at the same time.
CONNECTING PANEL DESCRIPTION