Fitting Guide | Roger and MED-EL audio processors SONNET, RONDO and OPUS 2 3
Listening check
Product name
MLx Audio Checker and Roger X
Roger X plugged directly into the MLx Audio Checker
Adapter / Roger receiver
Using Roger via the T-Coil
Alternatively, the receiver Roger MyLink can be used after
activating the T-Coil in the audio processor.
RONDO:
For the best orientation of the integrated T
‐
Coil, please wear the RONDO with microphone on top position.
Special features for educational system
2
Programming of EasyGain
If the volume of the Roger system is not satisfactory, you can
change the gain of the receiver via Roger inspiro. Hold Roger
inspiro close to Roger X (less than 10 cm/4 inches) and press
Check
.
Roger X information will appear on the inspiro’s screen.
Press
Manage
, scroll with the cursor to
EasyGain
and press
OK
.
Now you can change the gain of the receiver in the range
of -8 dB to +8 dB.
By programming a dedicated CI setting, the AutoConnect feature in the Roger X
2
will be disabled, which also deactivates the beep
tone at start-up.
1.
Connect Roger X to the audio processor.
2.
Turn Roger inspiro on, hold it close to Roger X (less than 10 cm/4 inches) and select the function
Check
.
3.
Click
Manage
, scroll to ‘
CI module
’ then click
OK
.
4.
Scroll to the corresponding value as shown in the table below and click
OK
again.
Model
Roger X setting
MED-EL SONNET
Setting 3
MED-EL RONDO
Setting 2
MED-EL OPUS 2
Setting 2
2
Available for Roger X (02) only
V2
.01/
2014-
12/
©
Pho
na
k
A
G
A
ll
ri
ght
s
re
se
rv
ed
