8
A. Attach the front (center) section of the column to the base
using 2, 1/4-
20 x 1/2” hex head bolts, 4 flat washers and
2 Kep nuts.
(Fig. A)
B. Attach the two (2) sides of the column to the base using
4, 1/4-
20 x 1/2” hex head bolts, 8 flat washers and 4 Kep
nuts. (
Fig. B)
NOTE: Washers should be placed
after the hex head and before the
Kep nuts. Follow through-out as-
sembly.
C. Attach sides of column sections using 6 1/4-
20 x 1/2” hex
head bolts, 12 flat washers and 6 Kep nuts.
D. Insert heat shield into top of column using 8 1/4-20
X 1/2” hex head bolts, 16 flat washers and 8 Kep
nuts.
(Fig. D)
E. Lay base on its side and place caster stem into
stem opening of base, press and snap into place.
(Fig. E)
F. Attach the tank lock bar across the back of the col
umn. Use the 3/4” Hex bolt, 4 Flat Washers, Nylon
Spacer and the Kep nut on each side to fasten the
bar in place. (
Fig. E-1)
Fig. A
Fig. B
Heat Shield
Fig. D
Fig. E
Step 2:
Mounting Grill Fire Pit to Column
.
A. Set the grill pit onto the top of the column and align the 6 pit
mounting holes to the matching holes in the column lip.. Install
the 6 hex bolts, 12 washers and 6 Kep nuts. Tighten securely.
(Fig. F)
Fig. F
Step 3:
Attaching Control Panel
to Grill Pit
.
Threaded Studs
NOTE:
The control panel has two (2) threaded
studs with a spacer nut that mounts to the fire pit
allowing airflow between the pit and control panel.
Also, the control panel comes with factory preas-
sembled gas regulator, hose and igniter.
(Fig. G)
Fig. G
Step 1:
Mounting Column to Base
.
Grill
Flat Washers
Hex Headl
Kep Nut
Tank Locking Bar
Propane Model
Nylon Spacer
Hex Bolt
Kep Nut
Fig. E-1
Flat Washer
Grill
