Phoenix Model westland lysander, Инструкция по эксплуатации, Страница: 35 / 48

INSTALLING THE SPINNER
Install the spinner back-plate, propeller and
spinner cone.
The propeller should not touch any part of the
spinner cone. If it dose, use a sharp modeling
knife and carefully trim away the spinner cone
where the propeller comes in contact with it.
!
3x12mm TP Screw
4
INSTALLING THE SWITCH
1. The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting
holes.
2. Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
3. Secure the switch in place using the two machine
screws provided with the radio system.
!
INSTALLING THE RECEIVER AND BATTERY
1. Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the
switch.
2. Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
Do not permanently secure the receiver and battery
until after balancing the model.
Must be purchased
separately!
WESTLAND LYSANDER
Instruction Manual
34
Spinner
Propeller
Spinner
3x12mm
3x12mm