Phoenix Model PH 165-OUTRAGEOUS, Инструкция по эксплуатации

Страница: 32 / 48

OUTRAGEOUS
Instruction Manual
31
Cut off shaded portion
< Throttle Idling >
approx. 1mm
Carburetor
Throttle Servo
Throttle position of Tx.
< Throttle Hi > < Throttle Stop >
MOUNTING THE COWL
1. Remove the muffler and needle valve assembly
from the engine. Slide the fiberglass cowl over
the engine.
2. Measure and mark the locations to be cut out
for engine head clearance, needle valve,
muffler. Remove the cowl and make these
cutouts using a rotary tool with a cutting disc
and a rotary sanding drum attachment.
3. Slide the cowl back into place. Align the front of
the cowl with the crankshaft of the engine. The
front of the cowl should be positioned so the
crankshaft is in the middle of the precut
opening. Hold the cowl firmly in place using
several pieces of masking tape.
4. While holding the cowl firmly in position, drill
four 1,6mm pilot holes through both the cowl
and the side edges of the firewall.
5. Using a 3mm drill bit, enlarge the holes in the
cowling.
Enlarging the holes through the cowl will prevent
the fiberglass from splitting when the mounting
screws are installed.
6. Slide the cowl back over the engine and secure it
in place using screws.
7. Install the muffler. Connect the fuel and pressure
lines to the carburator, muffler and fuel filler
valve. Tighten the screws completely.
!
3 x 15mm TP Screw
6
Trim the cowling so it will
match your engine
Washer
5mm